Mvme712M Transition Module Installation - Motorola MVME2700 Series Installation And Use Manual

MVME712M Transition Module Installation

This section applies to MVME712M-compatible models of the
MVME2700 VMEmodule. With the MVME2700 installed, refer to
3-4 and proceed as follows to install an MVME712M transition module:
1. Attach an ESD strap to your wrist. Attach the other end of the ESD
2. Perform an operating system shutdown. Turn the AC or DC power
3. Remove the filler panel(s) from the appropriate card slot(s) at the
4. Attach the P2 adapter board to the P2 backplane connector at the slot
5. Route the 64-conductor cable furnished with the MVME712M from
6. Secure the MVME712M in the chassis with the screws provided,
7. Referring to the user's manual for the MVME712M, listed in the
Note
http://www.mcg.mot.com/literature
strap to the chassis as a ground. The ESD strap must be secured to
your wrist and to ground throughout the procedure.
off and remove the AC cord or DC power lines from the system.
Remove chassis or system cover(s) as necessary for access to the
VMEmodules.
front or rear of the chassis. You may need to shift other modules in
the chassis to allow space for the MVME712M, which has a double-
wide front panel.
occupied by the MVME2700 VMEmodule.
J2 on the P2 adapter board to J2 on the transition module. Be sure to
orient cable pin 1 with connector pin 1.
making good contact with the transverse mounting rails to minimize
RF emissions.
Related Documentation
the internal or external SCSI devices as appropriate to your system
configuration. Be sure to orient cable pin 1 with connector pin 1.
The SCSI cabling can be installed in a number of ways to suit
various device and system configurations.
a possible configuration for use with internal SCSI devices.
MVME712M Transition Module Installation
appendix, route the 50-conductor cable to
Figure 3-4
Figure
3
shows
3-11