Installing Transition Modules And Adapter Boards; Connecting Peripherals; Transition Module And Adapter Board Installation Overview - Motorola MVME167 Series Installation Manual

Installing Transition Modules and Adapter Boards

Table 3-11. Transition Module and Adapter Board Installation Overview
Stage What you will need to do...
1 Set jumpers on the transition
module(s) and install SCSI
terminators (if needed) on the P2
adapter board.
2 Connect and install the MVME712X
transition module
rear of the chassis
Connect and install
3
The P2 adapter board at the
P2 connector on the
backplane at the MVME167
slot.
SCSI cable(s) from the P2
adapter board to the
MVME712X transition
module and internal SCSI
devices.

Connecting Peripherals

The MVME167 mates with (optional) terminals or other peripherals
at the EIA-232-D serial ports (marked SERIAL PORTS 1, 2, 3, and 4
on the MVME712X transition module), parallel port, SCSI ports,
and LAN Ethernet port, as shown in
Note
in the front or the
.
Some cable(s) are not provided with the MVME712X
module(s), and therefore are made or provided by the
user. (Motorola recommends using shielded cables for
all connections to peripherals to minimize radiation.)
Installing the Hardware
Refer to...
Module Preparation in the userÕs
manual for your transition module
and adapter board, and SCSI Bus
Termination on page 3-28
Installation Instructions in the userÕs
manual for your transition module
and adapter board
Installation Instructions in the userÕs
manual for your transition module
and adapter board
Module Preparation in the userÕs
manual for your transition module
and adapter board, and SCSI Bus
Termination on page 3-28
Figure 3-4 on page
3
3-22.
3-19