Tmcp700 Transition Module Installation - Motorola MCP750 Installation And Use Manual

Hardware Preparation and Installation
1

TMCP700 Transition Module Installation

!
Caution
!
Warning
!
Caution
1-24
The TMCP700 Transition Module may be required to complete the
configuration of your particular MCP750 system. If so, perform the
following steps to install this board. For additional information on the
TMCP700 Transition Module refer, to the TMCP700 Transition Module
Installation and Use manual (TMCP700A/IH).
1. Attach an ESD strap to your wrist. Attach the other end of the strap
to the chassis as a ground. The ESD strap must be secured to your
wrist and to ground throughout the procedure.
2. Perform an operating system shutdown. Turn the AC or DC power
off and remove the AC cord or DC power lines from the system.
Remove chassis or system cover(s) as necessary for access to the
chassis backplane.
Inserting or removing modules with the power applied may result in
damage to the module components.
To prevent injury, use extreme caution when handling, testing, and
adjusting this equipment. Dangerous voltages capable of causing death
exist.
3. If Serial Ports 3 and 4 are used, be sure they are properly configured
on the TMCP700 before installing the board. Refer to the section
titled TMCP700 Transition Module Preparation
how to do this.
Avoid touching areas of integrated circuitry; static discharge can damage
these circuits.
4. With the TMCP700 in the correct vertical position that matches the
pin positioning of the corresponding MCP750 board, carefully slide
the transition module into the appropriate slot and seat tightly into
for instructions on
Computer Group Literature Center Web Site