Motorola MVME2700 Series Installation And Use Manual page 25

Mvme2700 series single board computer
Hide thumbs Also See for MVME2700 Series:
Table of Contents

Advertisement

Hardware Preparation
2
Serial Port 3 Transmit Clock Configuration (J18)
2-6
As described in other sections, a complete configuration of serial port 4
requires that you set additional jumper headers on the MVME2700 or the
transition module.
J19
2
1
Buffer Enabled
(factory configuration)
Serial port configurations for the MVME712M are illustrated in figures
2-4
through 2-9.
Serial port configurations for the MVME761 are illustrated in figures
through 2-28.
On MVME761-compatible versions only of the base board, this header
configures port 3 to either drive or receive TxC. The factory configuration
has serial port 3 set to receive TxC. On MVME761-compatible versions,
you must set J2 on the transition module to complete the configuration of
serial port 3.
J18
3
2
1
Drive TxC
Serial port configurations for the MVME712M are illustrated in figures
2-4
through 2-9.
Serial port configurations for the MVME761 are illustrated in figures
through 2-28.
J19
2
1
Buffer Disabled
J18
3
2
1
Receive TxC
(factory configuration)
Computer Group Literature Center Web Site
2-11
2-11

Advertisement

Table of Contents
loading

Table of Contents