Motorola MVME2700 Series Installation And Use Manual page 159

ROM Boot Direct Ending Address = FFFFFFFC?
The last location tested when PPCBug searches for a ROMboot module.
(Default = $FFFFFFFC)
Network Auto Boot Enable [Y/N] = N?
Network Auto Boot at power-up only [Y/N] = N?
Network Auto Boot Controller LUN = 00?
Refer to the PPCBug Firmware Package User's Manual for a listing of
disk/tape controller modules currently supported by PPCBug.
(Default = $00)
Network Auto Boot Device LUN = 00?
Refer to the PPCBug Firmware Package User's Manual for a listing of
disk/tape controller modules currently supported by PPCBug.
(Default = $00)
Network Auto Boot Abort Delay = 5?
The time in seconds that the NETboot sequence delays before starting the
boot. The purpose for the delay is to allow you the option of stopping the
boot by use of the
(Default = 5 seconds)
Network Auto Boot Configuration Parameters Offset (NVRAM) =
00001000?
The address where the network interface configuration parameters are to
be saved/retained in NVRAM; these parameters are the necessary
parameters to perform an unattended network boot. A typical offset might
be $1000, but this value is application-specific.
(Default = $00001000)
http://www.mcg.mot.com/literature
Y The Network Auto Boot (NETboot) function is
enabled.
The NETboot function is disabled. (Default)
N
NETboot is attempted at power-up reset only.
Y
NETboot is attempted at any reset. (Default)
N
key. The time value is from 0-255 seconds.
BREAK
ENV - Set Environment
8-9
8