Mvme2700 Vmemodule Installation - Motorola MVME2700 Series Installation And Use Manual

MVME2700 VMEmodule Installation

With mezzanine board(s) installed and headers properly configured,
proceed as follows to install the MVME2700 in the VME chassis:
1. Attach an ESD strap to your wrist. Attach the other end of the ESD
2. Perform an operating system shutdown. Turn the AC or DC power
3. Remove the filler panel from the card slot where you are going to
4. Slide the MVME2700 into the selected card slot. Be sure the module
5. Secure the MVME2700 in the chassis with the screws provided,
6. On the chassis backplane, remove the
Note
http://www.mcg.mot.com/literature
strap to the chassis as a ground. The ESD strap must be secured to
your wrist and to ground throughout the procedure.
off and remove the AC cord or DC power lines from the system.
Remove chassis or system cover(s) as necessary for access to the
VMEmodules.
install the MVME2700.
– If you intend to use the MVME2700 as system controller, it must
occupy the leftmost card slot (slot 1). The system controller must
be in slot 1 to correctly initiate the bus-grant daisy-chain and to
ensure proper operation of the IACK daisy-chain driver.
– If you do not intend to use the MVME2700 as system controller,
it can occupy any unused double-height card slot.
is well seated in the P1 and P2 connectors on the backplane. Do not
damage or bend connector pins.
making good contact with the transverse mounting rails to minimize
RF emissions.
(IACK) and
BUS GRANT
slot occupied by the MVME2700.
Some VME backplanes, such as those used in Motorola
''Modular Chassis'' systems, have an autojumpering feature
for automatic propagation of the IACK and BG signals. Step
6 does not apply to such backplane designs.
MVME2700 VMEmodule Installation
INTERRUPT ACKNOWLEDGE
(BG) jumpers from the header for the card
3
3-9