Figure 2-10. Mvme712M Three-Row P2 Adapter - Motorola MVME2700 Series Installation And Use Manual

P2 Adapter Preparation
In its factory configuration, the MVME712M transition module uses a
three-row P2 adapter to transfer synchronous/asynchronous serial,
parallel, and Ethernet signals to and from the MVME2700 series
VMEmodule. A 50-pin male connector (J3) on the P2 adapter carries 8-bit
SCSI signals from the MVME2700.
Preparation of the three-row P2 adapter for the MVME712M consists of
removing or installing the SCSI terminating resistors, R1-R3.
illustrates the location of the resistors, the connectors, and SCSI terminator
power fuse F1. For further information on the preparation of the transition
module and this P2 adapter, refer to the user's manual for the
MVME712M, listed in

Figure 2-10. MVME712M Three-Row P2 Adapter

If you plan to connect the MVME712M to a VME64 backplane with a
five-row P2 adapter refer to
adapter.
http://www.mcg.mot.com/literature
Related
A1
B1
C1
2
1
1 R1
C1 C2
C1
B1
A1
MVME712M Transition Module Preparation
Documentation.
J2
J3
R2 R3
C3
CR1
P2
on page 2-27 for guidelines on preparing the
Figure 2-10
A32
B32
C32
1
50
2
49
F1
C32
B32
A32
cb211 9212
2-17
2