Motorola MVME2700 Series Installation And Use Manual page 67

Hardware Installation
3
3-8
5. Remove the LED module screw located at the upper front corner of
the base board. Install a short (0.394 inch) standoff in its place.
6. At the other three corners of the base board, install long (0.737 inch)
standoffs.
7. Place the PMC carrier board on top of the base board. The connector
on the underside of the carrier board should connect smoothly with
the corresponding connector J4 (located between P1 and P2) on the
MVME2700.
– If you plan to install a second carrier board as well, secure the
bottom board to the MVME2700 by threading a set of long
standoffs through the holes at the corners of the board. Then seat
the second carrier board upon it.
8. Insert the four short Phillips screws through the holes at the corners
of the carrier board, into the standoffs on the MVME2700 (or, if
applicable, the lower carrier board). Tighten the screws.
9. Reinstall the MVME2700 assembly in the proper card slots. Be sure
the assembly is well seated in the backplane connectors. Do not
damage or bend connector pins.
10. Replace the chassis or system cover(s), reconnect the system to the
AC or DC power source, and turn the equipment power on.
Computer Group Literature Center Web Site