Mvme167P And Transition Module Installation - Motorola MVME167P Installation And Use Manual

4. Remove the filler panel from the card slot where you are going to
install the MVME167P.
5. Slide the MVME167P into the selected card slot. Be sure the module
is seated properly in the P1 and P2 connectors on the backplane. Do
not damage or bend connector pins.
6. Secure the MVME167P in the chassis with the screws provided,
making good contact with the transverse mounting rails to minimize
RF emissions.
7. Install the MVME712 series transition module in the front or the rear
of the VME chassis. (To install an MVME712M, which has a double-
wide front panel, you may need to shift other modules in the chassis.)
8. On the chassis backplane, remove the
(IACK) and
occupied by the MVME167P.
Note
9. Connect the P2 adapter board or LCP2 adapter board and cable(s) to
MVME167P backplane connector P2. This provides a connection
point for terminals or other peripherals at the EIA-232-D serial ports,
parallel port, SCSI port, or LAN Ethernet port. For information on
installing the P2 or LCP2 Adapter Board and the MVME712 series
transition module(s), refer to the corresponding user's manuals (the
Programmer's Reference Guide provides some connection diagrams).
http://www.motorola.com/computer/literature

MVME167P and Transition Module Installation

If you intend to use the MVME167P as system controller, it
must occupy the leftmost card slot (slot 1). The system
controller must be in slot 1 to correctly initiate the bus-grant
daisy-chain and to ensure proper operation of the IACK daisy-
chain driver.
If you do not intend to use the MVME167P as system
controller, it can occupy any unused double-height card slot.
(BG) jumpers from the header for the card slot
BUS GRANT
Some VME backplanes (e.g., those used in Motorola
"Modular Chassis" systems) have an autojumpering feature
for automatic propagation of the IACK and BG signals. Step
8 does not apply to such backplane designs.
INTERRUPT ACKNOWLEDGE
1
1-13