Unpacking Instructions; Hardware Configuration - Motorola MVME2700 Series Installation And Use Manual

Introduction to the MVME2700
1

Unpacking Instructions

!
Caution

Hardware Configuration

1-6
Note If the shipping carton is damaged upon receipt, request that
the carrier's agent be present during the unpacking and
inspection of the equipment.
Unpack the equipment from the shipping carton. Refer to the packing list
and verify that all items are present. Save the packing material for storing
and reshipping of equipment.
Avoid touching areas of integrated circuitry; static discharge
can damage circuits.
To produce the desired configuration and ensure proper operation of the
MVME2700, you may need to carry out certain hardware modifications
before installing the module.
The MVME2700 provides software control over most options: by setting
bits in control registers after installing the module in a system, you can
modify its configuration. The MVME2700 control registers are described
in Chapter 5, and/or in the MVME2600 Series Single Board Computer
Programmer's Reference Guide listed under
Some options, however, are not software-programmable. Such options are
controlled through manual installation or removal of header jumpers or
interface modules on the base board or the associated transition module.
Instructions on preparing the base board, transition modules and P2
adapter are covered in
board, memory mezzanine, transition modules and P2 adapter are covered
in Chapter 3.
Related
Chapter 2. Installation instructions for the base
Computer Group Literature Center Web Site
Documentation.