Chapter 2 Hardware Preparation; Mvme2700 Base Board Preparation; Table 2-1. Jumper Settings - Motorola MVME2700 Series Installation And Use Manual

Hardware Preparation

MVME2700 Base Board Preparation

2
2-2
Figure 2-1 illustrates the placement of the switches, jumper headers,
connectors, and LED indicators on the MVME2700. Manually
configurable items on the base board are listed in the following table. Refer
to the sections or figures listed along side the jumper function for more
information.

Table 2-1. Jumper Settings

Jumper
J9 Flash bank selection, page
J20 System controller selection, page
J18 SP3 transmit clock configuration, page
J16 SP4 receive clock configuration, page
J17 SP4 transmit clock configuration, page
J19 SP4 transmit clock receiver buffer control, page
In conjunction with the serial port settings on the base board, serial ports
on the associated MVME712M or MVME761 transition module are also
manually configurable. For a discussion of the configurable items on the
transition module, refer to the
Preparation and MVME761 Transition Module Preparation
further information, refer to the
The MVME2700 is factory tested and shipped with the configurations
described in the following sections. The MVME2700's required and
factory-installed debug monitor, PPCBug, operates with those factory
settings.
Function
2-4
2-7
2-6
2-4
2-5
MVME712M Transition Module
Related Documentation
Computer Group Literature Center Web Site
2-5
sections. For
appendix.