Motorola MVME2700 Series Installation And Use Manual page 163

Configure the VMEbus Interface
ENV asks the following series of questions to set up the VMEbus interface
for MVME2600/MVME2700/MVME3600/MVME4600 series
VMEmodules. To perform this configuration, you should have a working
knowledge of the Universe II ASIC as described in the Programmer's
Reference Guide.
VME3PCI Master Master Enable [Y/N] = Y?
PCI Slave Image 0 Control = 00000000?
The configured value is written into the LSI0_CTL register of the Universe
II chip.
PCI Slave Image 0 Base Address Register = 00000000?
The configured value is written into the LSI0_BS register of the Universe
II chip.
PCI Slave Image 0 Bound Address Register = 00000000?
The configured value is written into the LSI0_BD register of the Universe
II chip.
PCI Slave Image 0 Translation Offset = 00000000?
The configured value is written into the LSI0_TO register of the Universe
II chip.
PCI Slave Image 1 Control = C0820000?
The configured value is written into the LSI1_CTL register of the Universe
II chip.
PCI Slave Image 1 Base Address Register = 01000000?
The configured value is written into the LSI1_BS register of the Universe
II chip.
http://www.mcg.mot.com/literature
Set up and enable the VMEbus Interface (Default)
Y
Do not set up or enable the VMEbus Interface.
N
ENV - Set Environment
8-13
8