Uninstalling The Client Adapter Software - Cisco CB21AG Installation And Configuration Manual

Client Adapter Software Procedures

Uninstalling the Client Adapter Software

This section provides instructions for uninstalling the software for your Cisco Aironet CB21AG or
PI21AG client adapter. This procedure is necessary if you want to remove installed client adapter
software from your computer or downgrade to a previous release.
Note If you want to downgrade to an earlier release of client adapter software, use this procedure to uninstall
the current software. Then install the older software.
Note When you uninstall the client adapter software, any existing profiles and stored PAC files are removed.
If you want to save your profiles for later use, follow the instructions in
before uninstalling the software.
Step 1 Perform one of the following:
•
•
Step 2 Use Windows Explorer to find the Install Wizard file.
Note
Step 3 Double-click the file. The "Starting InstallShield Wizard" message appears followed by the Preparing
Setup window (see
Step 4 Choose Uninstall the previous installation and click Next.
Step 5 When a message appears indicating that you are required to restart your computer at the end of the
operation, click Yes. (If you click No, you are asked to confirm your decision. If you proceed, the
installation process terminates.)
Step 6 When prompted to confirm your decision, click OK. The process to uninstall the files begins.
Step 7 When prompted to uninstall the device driver, click Yes.
When a message appears indicating that your computer needs to be rebooted, click OK and allow your
Step 8
computer to restart.
Step 9 If you did not remove the client adapter from your computer, the Found New Hardware Wizard window
appears after your computer reboots. Click Cancel. The client adapter software and its program folder
have been uninstalled.
Note This procedure does not remove the Install Wizard file. If you want to remove it from your computer,
find the file using Windows Explorer and delete it.
Cisco Aironet 802.11a/b/g Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide
9-6
If you want to remove the client adapter from your computer, shut down your computer, remove the
client adapter, and reboot your computer. Then go to
If you want to leave your client adapter inserted in your computer, go to
If you do not have the Install Wizard's setup.exe file, you can access the client adapter software
by clicking Control Panel > Add/Remove Programs > Cisco Aironet Installation Program
> Remove. Then follow the steps below beginning with the Preparing Setup window in
Figure 9-1) and the Previous Installation Detected window (see
Chapter 9
Chapter 4 to export your profiles
Step 2.
Step 2.
Figure
Routine Procedures
Step 3.
9-2).
OL-4211-03