Pausing The Ap Scan List - Cisco CB21AG Installation And Configuration Manual

Appendix F Performing a Site Survey
Table F-2
AP Scan List Parameter Description
AP Name
CCX
Other Information

Pausing the AP Scan List

The AP scan list is updated continually. To pause the current list, click Pause List Update above the AP
scan list.
Clicking this button again resumes the list update.
Note
Cisco Aironet 802.11a/b/g Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide for Windows
OL-4211-03
Site Survey Utility - AP Scan List (continued)
The access point's name. It is shown only if the access point was configured
with a name, Aironet Extensions are enabled (on access points running Cisco
IOS Release 12.2(4)JA or later), and the access point transmits this
information.
Note This field shows up to 15 characters although the name of the access
point may be longer.
The version of Cisco Compatible Extensions (CCX) supported by the access
point. It is shown only if the access point transmits this information.
Value: 1, 2, 3, or 4
A list of miscellaneous values that may appear depending on the access
point's current status and the information that it transmits.
Values: Ad-Hoc, Power, Qos, RM-Normal, RM-Source, and Ssidl
Value
Ad-Hoc
Power
Qos
RM-Normal
RM-APScan
RM-CliWlk
RM-Source
Ssidl
Description
Indicates that the device is not an access point but another
client adapter operating in ad hoc mode.
Indicates whether the access point can limit the transmitting
power of the client adapter. If so, the power limit is also shown
in milliwatts (mW).
Indicates whether the access point is using quality of service
(QoS). QoS on wireless LANs (WLAN) provides
prioritization of traffic from the access point over the WLAN
based on traffic classification.
Indicates whether the access point is using radio management.
If so, a value of 1 indicates normal status, 2 indicates AP radio
scan, and 3 indicates client walkabout. Any other value
appears as RM-State:xxx, where xxx represents a numerical
value.
Indicates whether the access point is using radio management
extensions and displays the MAC address of the radio
management source (for example, RM-Source:
00-07-85-B4-04-9F).
Indicates the number of advertised alternate SSIDs (for
example, Ssidl:2).
Using the AP Scan List Tab
F-11