Cisco CB21AG Installation And Configuration Manual page 116

Setting Security Parameters
Step 5 Click Start > Settings > Control Panel > Network and Dial-up Connections or Network Connections.
Step 6 Right-click your wireless connection.
Step 7 Click Properties. The Connection Properties window appears.
Step 8 Perform one of the following:
On Windows 2000, click the Authentication tab.
•
On Windows XP, choose the Wireless Networks tab, make sure that the Use Windows to configure
•
my wireless network settings check box is checked, click the SSID of the access point to which
you want the client adapter to associate from the list of available networks, click Configure, and
choose the Authentication tab.
Step 9 For EAP type, choose Protected EAP (PEAP).
Configure any applicable settings on the Protected EAP Properties window and subwindows.
Step 10
Note
After you have finished the configuration, PEAP authentication should begin. Depending on the
Step 11
configuration settings you selected, you may be prompted for your PEAP username, password, and
domain name. Note that you may need to minimize ADU in order to access the pop-up window that
prompts you for your credentials.
You can have multiple host-based EAP profiles in ADU, but the Microsoft Wireless Configuration
Note
Manager maintains only one configuration. If you want to use different PEAP property settings for
different host-based EAP profiles, you need to repeat the previous steps beginning with Step 4 every time
you switch to a different host-based EAP profile.
Note When you activate a host-based EAP profile, the Microsoft Wireless Configuration Manager takes
control of the client adapter's authentication attempt. However, when you activate a non-host-based EAP
profile, ADU assumes this control.
Note If you experience problems while using a host-based EAP profile, make sure that 802.1X authentication
is disabled for any other network connection.
Cisco Aironet 802.11a/b/g Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide
5-50
Refer to the "Enabling PEAP (EAP-MSCHAP V2)" section on page E-14
configuring the PEAP (EAP-MSCHAP V2) settings.
Chapter 5 Configuring the Client Adapter
if you need help
OL-4211-03