Tool Tip Window - Cisco CB21AG Installation And Configuration Manual

Chapter 8 Using the Aironet System Tray Utility (ASTU)
Table 8-1
Icon

Tool Tip Window

When you hover the cursor over the ASTU icon, the Tool Tip window appears (see
If the client adapter's radio is disabled, a message appears instead of the Tool Tip window to inform you
Note
that the wireless network interface is disabled.
Figure 8-1
This window provides information on the current status of your client adapter.
describes each element of the Tool Tip window.
Table 8-2
Status Element
Active profile
SSID
Cisco Aironet 802.11a/b/g Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide
OL-4211-03
Interpreting the ASTU Icon (continued)
Description
A yellow icon indicates that the client adapter is associated to an access point (in
infrastructure mode) or another client (in ad hoc mode), the user is authenticated if the
client adapter is configured for EAP authentication, and the signal strength is fair.
A red icon indicates that the client adapter is associated to an access point (in
infrastructure mode) or another client (in ad hoc mode), the user is authenticated if the
client adapter is configured for EAP authentication, and the signal strength is poor.
Tool Tip Window
Tool Tip Window Elements
Description
The network configuration (or profile) that your client adapter is
currently using.
Note If auto profile selection is enabled, the active profile does not
appear until the client is associated to an access point.
The name of the network to which your client adapter is currently
associated.
Note When the client adapter is not associated and auto profile
selection is disabled, this field shows the profile's SSID. When
the client adapter is not associated and auto profile selection is
enabled, this field is left blank.
Note Refer to the SSID1 parameter in
setting the client adapter's SSID.
Tool Tip Window
Figure 8-1).
Table 8-2 lists and
Table 5-2 for information on
8-3