Assembling The Antenna - Cisco CB21AG Installation And Configuration Manual

Chapter 3 Installing the Client Adapter
Figure 3-3
1
2
3
Step 6 Tilt the card to enable the LEDs to slip through the opening in the CPU back panel. See the enlarged
view in
Step 7 Press the card into the empty slot until its connector is firmly seated.
Caution Do not force the card into the expansion slot; this could damage both the card and the slot. If the card
does not insert easily, remove it and reinsert it.
Reinstall the screw on the CPU back panel and replace the computer cover.
Step 8

Assembling the Antenna

Follow the steps below to assemble the PCI card's antenna.
Slide the antenna through the opening in the bottom of the antenna base.
Step 1
Step 2 Position the antenna so its notches are facing the Cisco label on the front of the base. See
Cisco Aironet 802.11a/b/g Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide
OL-4211-03
Inserting a PCI Card into a PC
2
1
Antenna cable
LEDs
Card edge connector
Figure 3-3.
3
Inserting a Client Adapter
Figure 3-4.
3-5