Cisco CB21AG Installation And Configuration Manual page 94

Setting Security Parameters
Follow the steps below to enable LEAP authentication for this profile.
Perform one of the following on the Profile Management (Security) window:
Step 1
If you want to enable LEAP without WPA or WPA2, choose 802.1x under Set Security Options and
•
LEAP in the 802.1x EAP Type drop-down box.
If you want to enable LEAP with WPA or WPA2, choose WPA/WPA2/CCKM under Set Security
•
Options and LEAP in the WPA/WPA2/CCKM EAP Type drop-down box.
Note
Note
Click Configure. The LEAP Settings window appears (see
Step 2
Figure 5-7
Cisco Aironet 802.11a/b/g Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide
5-28
If you want to enable CCKM on the client adapter, you must choose the WPA/WPA2/CCKM
security option, regardless of whether you want the adapter to use WPA or WPA2. The
configuration of the access point to which your client adapter associates determines whether
CCKM will be used with 802.1x, WPA, or WPA2.
Refer to the "WPA and WPA2" section on page 5-18
LEAP Settings Window
Chapter 5 Configuring the Client Adapter
for additional information.
Figure 5-7).
OL-4211-03