Table of Contents
Advertisement
Caution:
!
When printing on multipart forms, make sure that your software settings keep the printing
entirely within the printable area of the forms. Printing on the edge of a multipart form can
damage the print head. For information about the printable area, see "Printable area" on
page 121.
Labels
You can use two types of labels: single-sheet and continuous forms. Do not use labels on shiny
single sheet backing, because the backing sheet tends to slip and may not feed properly.
Follow these steps to load labels:
Caution:
!
Use labels only under normal operating conditions because labels are especially sensitive to
temperature and humidity.
Before printing, set the paper-thickness lever to the appropriate position for your labels referring
to the table in "Adjusting the Paper-thickness lever" on page 31.
1. Make sure of the following:
❏ Your software settings keep the printing entirely within the printable area. For information
about the printable area, see "Printable area" on page 121.
Caution:
!
Printing on the edge of a label can damage the print head.
❏ The auto tear off function is turned off in the Default Setting mode.
2. Load labels as described in "Loading Single Sheets" on page 39 or "Loading Continuous Paper"
on page 33.
To tear off and eject labels
When using continuous forms, always tear off and eject labels as described below.
Caution:
!
Never feed labels backward using the Load/Eject. Labels can easily peel off their backing and
jam the printer.
LQ-690II/LQ-690IIN
User's Guide
Paper Handling
42
Advertisement
Table of Contents
