Table of Contents
Advertisement
Cautions
CAUTION
Caution Labels
The caution labels on the product indicate the following precautions.
CAUTION:
Do not touch the thermal head and the frame on its side because it can be very hot after printing.
• Do not use this product in locations subject to high humidity or dust levels. Excessive humidity
and dust may cause paper jams and other problems, such as fire, or electric shock.
• Be sure to set this product on a firm, stable, horizontal surface. The product may break or cause
injury if it falls.
• Do not stand on or place heavy objects on top of this product. Equipment may fall or collapse,
causing breakage and possible injury.
• Be sure to use this product with the connector cover attached. If it is not attached, foreign
objects may enter this product, causing fire or equipment damage.
• When you move this product, be sure to hold the main body. If you hold only the connector
cover, it may come off and the main body may break or cause injury if it falls.
• The print head can be very hot during and immediately after printing. If you need to touch it,
such as for cleaning, wait until it cools down. Touching it before that may cause burns.
• Be careful of the cutter blades of the printer.
• Make sure that the total power requirements of all devices receiving power from this product do
not exceed the power supplying capability of the product. Otherwise, the devices may be dam-
aged.
• Connecting an outdoor overhead LAN cable directly to this product may lead to lightning dam-
age. If you need to connect such a cable to the product, the cable must be protected against an
electrical surge between the cable and the product. You should avoid connecting the product to
a non-surge protected outdoor overhead LAN cable.
• Do not connect a telephone line to the drawer kick connector of this product. The telephone
line or product may become damaged.
• To ensure safety, unplug this product before leaving it for an extended period.
• Confirm the rated current of the external devices by checking the descriptions on the devices or
manuals. Do not use a device whose rated current is unclear.
• Connect the external devices only when those total rated current is less than 4.2 A.
• To power off the product, use the application or OS function. Do not use the operations shown
below unless the product cannot be turned off due to an application or OS problem. Doing so
may cause loss of unsaved data, require OS recovery, or damage the SSD or other hardware.
∗ Forced termination by holding down the power button for approx.4 sec.
∗ Power shutdown by turning off the circuit breaker on the distribution board or by disconnect-
ing the AC cable/DC cable
∗ The same phenomenon may also occur due to power shutdown caused by power failure/tem-
porary power failure.
5
Advertisement
Table of Contents
