Section 7-Seat And Arms; Removing/Installing The Seat - Invacare Lynx L-3X Owner's Operator And Maintenance Manual

SECTION 7—SEAT AND ARMS
After any adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service, turn power off and
remove key from ignition.
NOTE: Refer to Label Locations on page 7 for pinch point location.

Removing/Installing the Seat

Before use, ensure that the seat is in the locked position. The seat lever MUST be
pulled up to the 90° position to allow the seat to drop into the locked position. Oth-
erwise, a fall from the scooter could occur causing bodily injury and/or damage to
the scooter.
NOTE: For this procedure, refer to FIGURE 7.1.
NOTE: Seat lock lever located on left side of seat.
Removing
1. Fold down seat back.
2. Pull up the seat lock lever.
3. Lift the seat assembly up and away from the seat post.
Installing
1. Lower the seat assembly onto the seat post.
2. Pull the seat lock lever up to allow the seat to drop into the locked position.
3. Lift up on seat assembly to ensure the seat is secure.
Assembly
Part No. 1145807
WARNING
WARNING
Seat
Seat Post
FIGURE 7.1 Removing/Installing the Seat
SECTION 7—SEAT AND ARMS
Seat Lock Lever
27
Lynx™L-3X