Installing/Removing The Crutch/Cane Holder - Invacare Lynx L-3X User Manual

12 ACCESSORIES

12.1 Installing/Removing the Crutch/Cane Holder

WARNING
The installation of the crutch/cane holder onto the back of the scooter seat significantly increases the length of the scooter.
When turning the scooter or swiveling the scooter seat, it is important to take note of this increased length - otherwise,
injury and/or damage to the surrounding property may result.
 For this procedure, refer to FIGURE 12.1.
Installing
1. Install the crutch/cane holder into the accessory tube located on
the back of the seat.
2. Install the mounting knob to secure the crutch/cane holder in place.
Securely tighten.
3. Align the slot on the base with the hook on the crutch/cane holder
and slide base down into position.
Removing
1. Remove the crutch/cane holder from the accessory tube.
2. Remove the mounting knob that secures the crutch/cane holder in
place.
3. Remove the crutch/cane holder from the accessory tube.
Lynx™L-3X Scooter
Accessory
Tube
Crutch Cane
Holder
Hook
Base
FIGURE 12.1 Installing/Removing the Crutch/Cane Holder
52
Mounting Knob Installs in One
of These Locations
Insert Into
Accessory Tube
Part No. 1145807
Accessory
Tube