Configuring Radius Server Information - Dell PowerConnect 8024 User Configuration Manual

Command
passwords strength
exclude-keyword
passwords strength-
check
exit
show passwords
configuration
show passwords result

Configuring RADIUS Server Information

Beginning in Privileged EXEC mode, use the following commands to add
information about a RADIUS server to the switch.
NOTE:
Many of the commands that are available in RADIUS Configuration mode
are also available in Global Configuration mode to set global values for all
configured RADIUS servers for which explicit values have not been configured.
For example, to specify a global timeout value, enter radius-server timeout
seconds
in Global Config mode. To set a different timeout value for a specific
host, enter the RADIUS Configuration mode for that host and use the timeout
command.
Command
configure
radius-server host [acct |
ipaddress
auth] {
hostname
}
214
Controlling Management Access
Purpose
Specify up to three keywords to exclude in a password. The
word
password does not accept the keyword in any form (in
between the string, case in-sensitive and reverse) as a
substring.
Verify the strength of a password during configuration.
Exit to Privileged EXEC mode.
View the configured settings for passwords.
View information about the last password configuration
attempt and whether it was successful.
Purpose
Enter Global Configuration mode.
Specify a RADIUS server host and enter RADIUS
| Configuration mode.
• acct | auth — The type of server (accounting or
authentication). If no type is specified, the type is
authentication.
ipaddress
•
hostname
•
(Range: 1–255 characters).
— The RADIUS server host IP address.
— Host name of the RADIUS server host