Default Auto Configuration Values - Dell PowerConnect 8024 User Configuration Manual

Default Auto Configuration Values

Table 14-3 describes the Auto Configuration defaults.
Table 14-3. Auto Configuration Defaults
Feature
Auto Install
Mode
Retry Count
AutoSave
AutoReboot
366
Auto Image and Configuration Update
Default Description
Enabled When the switch boots and no saved configuration is
found, the Auto Configuration automatically begins.
3 When the DHCP or BootP server returns information
about the TFTP server and bootfile, the switch makes
three unicast TFTP requests for the specified bootfile. If
the unicast attempts fail or if a TFTP server address was
not provided, the switch makes three broadcast requests
to any available TFTP server for the specified bootfile.
Disabled If the switch is successfully auto-configured, the
running configuration is not saved to the startup
configuration.
Enabled After an image is successfully downloaded during the
Auto Configuration process, the switch automatically
reboots and makes the downloaded image the active
image.