Dell PowerConnect 8024 User Configuration Manual page 784

Command
ip arp inspection filter
acl-name vlan-range
vlan
[static]
interface
interface
ip arp inspection limit
pps
{none | rate
seconds
interval
ip arp inspection trust
CTRL + Z
show ip arp inspection
interface
interfaces [
show ip arp inspection
vlan-range
vlan [
show ip arp inspection
statistics [vlan
range
]
show arp access-list [
name
]
784
Snooping and Inspecting Traffic
Purpose
Configure the ARP ACL to be used for a single VLAN or a
range of VLANs to filter invalid ARP packets.
Use the static keyword to indicate that packets that do not
match a permit statement are dropped without consulting
the DHCP snooping bindings.
Enter interface configuration mode for the specified port
or LAG. The
and number, for example tengigabitethernet 1/0/3. For a
LAG, the interface type is port-channel.
You can also specify a range of ports with the interface
range command, for example, interface range
tengigabitethernet 1/0/8-12 configures interfaces 8, 9, 10,
11, and 12.
Configure the rate limit and burst interval values for an
[burst interface.Use the keyword none to specify that the
]} interface is not rate limited for Dynamic ARP Inspection.
• none — To set no rate limit.
pps
•
seconds
•
Specify that the interface as trusted for Dynamic ARP
Inspection.
Exit to Privileged EXEC mode.
View the Dynamic ARP Inspection configuration on all
] the DAI-enabled interfaces or for the specified interface.
View the Dynamic ARP Inspection configuration on the
] specified VLAN(s).
This command also displays the global configuration
values for source MAC validation, destination MAC
validation and invalid IP validation.
View the statistics of the ARP packets processed by
vlan-
Dynamic ARP Inspection for the switch or for the
specified VLAN(s).
acl-
View all configured ARP ACL and their rules, or use the
ACL name to view information about that ARP ACL only.
interface
variable includes the interface type
— Packets per second (Range: 0–300).
— The number of seconds (Range: 1–15).