What Factors Should Be Considered When Configuring Logging; Default Log Settings - Dell PowerConnect 8024 User Configuration Manual

• Line number —The line number which contains the invoking macro.
• Sequence number —The message sequence number for this stack
component. Sequence numbers may be skipped because of filtering but
are always monotonically increasing on a per-stack member basis.
• Message — Contains the text of the log message.

What Factors Should Be Considered When Configuring Logging?

Dell recommends that network administrators deploy a syslog server in their
network and configure all switches to log messages to the syslog server.

Default Log Settings

System logging is enabled, and messages are sent to the console (severity
level: warning and above), and RAM log (severity level: informational and
above). Switch auditing, CLI command logging, Web logging, and SNMP
logging are disabled. No messages are sent to the log file that is stored in flash,
and no remote log servers are defined.
Email alerting is disabled, and no recipient email address is configured.
Additionally, no mail server is defined. If you add a mail server, by default, no
authentication or security protocols are configured, and the switch uses TCP
port 25 for SMTP .
After you enable email alerting and configure the mail server and recipient
email address, log messages with a severity level of emergency and alert are
sent immediately with each log message in a separate mail. The email subject
is "Urgent Log Messages." Log messages with a severity level of critical, error,
and warning are sent periodically in a single email. The email subject is "Non
Urgent Log Messages." Messages with a severity level of notice and below are
not sent in an email.
Monitoring and Logging System Information
235