Configuring Priority-Based Flow Control - Dell PowerConnect 8024 User Configuration Manual

Command
show lldp tlv-select
interface {all |
show lldp dcbx interface
interface
{all status |
[detail]}

Configuring Priority-Based Flow Control

Beginning in Privileged EXEC mode, use the following commands to
configure PFC.
NOTE:
If DCBX is enabled, configuring PFC is not necessary because the DCBX
protocol automatically configures the PFC parameters.
Command
configure
interface
interface
datacenter-bridging
priority-flow-control
mode on
822
Configuring Data Center Features
Purpose
Display the interface TLV configuration for all interfaces
interface
} or for the specified interface.
Display the interface TLV configuration for all interfaces
or for the specified interface.
Purpose
Enter global configuration mode.
Enter interface configuration mode for the specified
interface. The
and number, for example tengigabitethernet 1/0/3.
You can also specify a range of interfaces with the interface
range command, for example, interface range
tengigabitethernet 1/0/8-12 configures interfaces 8, 9, 10,
11, and 12.
Enter the Data Center Bridging mode. PFC commands are
issued from within this mode.
Enable PFC on the interface(s)
NOTE:
enable if the lldp dcbx port-role auto-down command has
already been applied.
interface
variable includes the interface type
It is unnecessary to set the priority flow control to