Command
snmp-server host
addr
[informs [timeout
seconds
] [retries
| traps version {1 | 2}]]
community-string
port
port
] [filter
filtername
]
328
Configuring SNMP
Purpose
host-
For SNMPv1 and SNMPv2, configure the system to receive
SNMP traps or informs.
retries
]
host-addr
•
recipient) or the name of the host. (Range:1-158
[udp-
characters).
• informs — Indicates that SNMPv2 informs are sent to
this host
• timeout
acknowledgment before resending informs. The default is
15 seconds. (Range: 1-300 characters.)
retries
•
request. The default is 3 attempts.
• traps — Indicates that SNMP traps are sent to this host
– version 1 — Indicates that SNMPv1 traps will be used
– version 2 — Indicates that SNMPv2 traps will be used
community-string
•
community string sent with the notification operation.
(Range: 1-20 characters)
port
•
— UDP port of the host to use. The default is 162.
(Range: 1-65535 characters.)
filtername
•
defines the filter for this host. If unspecified, does not
filter anything (Range: 1-30 characters.)
— Specifies the IP address of the host (targeted
seconds
— Number of seconds to wait for an
— Maximum number of times to resend an inform
— Specifies a password-like
— A string that is the name of the filter that