Configuring L2 Multicast Features (CLI)
This section provides information about the commands you use to configure
L2 multicast settings on the switch. For more information about the
commands, see the
support.dell.com/manuals.
Configuring Bridge Multicasting
Beginning in Privileged EXEC mode, use the following commands to
configure MAC address table features.
Command
configure
mac address-table
multicast filtering
mac address-table
multicast static vlan
vlan-id
mac-multicast-
{
address
p-multicast-
| i
address
}
mac address-table
multicast static vlan
vlan-id
mac-multicast-
{
address
p-multicast-
| i
address
} [add|remove]
interface-list
interface
732
Configuring L2 Multicast Features
PowerConnect 8024/8024F CLI Reference Guide
Purpose
Enter global configuration mode.
Enable multicast filtering on the switch.
Register a MAC-layer Multicast address in the bridge
table.
mac-multicast-address
•
format xxxx.xxxx.xxxx.
ip- multicast-address
•
Add ports and LAGs to the multicast group as static
members.
• add — Adds ports to the group. If no option is specified,
this is the default option.
• remove — Removes ports from the group.
interface-list
•
channel, tengigabitethernet) and number. Separate
nonconsecutive interfaces with a comma and no spaces;
use a hyphen to designate a range of ports.
— MAC multicast address in the
— IP multicast address.
— Specifies the interface type (port-
at