Tools - Epson Stylus PRO 7000 Service Manual

EPSON Stylus Pro 7000
If you find it is necessary to perform service on a part not
described in this chapter, be sure to check the after-
service parts situation before beginning the service.
If you need to remove the ink tubes or other ink related
parts, see "Transportation Mode" on page 53 to drain the
ink before removing anything.
If necessary (i.e. when transporting the printer) use the
above mentioned mode to drain ink, install transportation
fluid cartridges (P/N1045585), and then perform an initial
ink charge with the fluid. Enter the transportation mode
again to remove the fluid (user can do) and then perform
initial ink charge with ink.
The directional instructions in this chapter are given as if
viewing the printer from the front. See the illustration
below.
L
Front
Figure 4-1. Directional View of the Printer
Disassembly & Assembly
Top
Rear
Bottom

4.1.2 Tools

This section lists the tools necessary to disassemble or assemble the printer.
Table 4-1. Necessary Tools
Tool
(+) Phillips screwdriver #2
(+) Phillips screwdriver #1
(-) Standard screwdriver
Round-nosed pliers
Tweezers
Hex (Allen key) wrench
#E589 torque wrench
(6mm x 1Kg)
#F733 Self Training Kit
transportation fluid
cartridges, S46, recycle
Maintenance Kit SP7000
R
Summary
Part Code
longer than 250mm is helpful
commonly available
tools, no special tools
necessary
Comes with stand,
5.5 mm for stand assembly
commonly available
only
tools also OK
B765106901 Tube lock tightener
1053426 CD-ROM based service tool
Transportation fluid cartridges
1045585
= six units required
Replacement parts for periodic
1054038
maintenance
Revision B
Notes
-
-
-
110