Epson Stylus PRO 7000 Service Manual page 132

EPSON Stylus Pro 7000
4.2.3.4 Removing the CR Board Assembly
1. Remove the R Side Cover as described in "R Side Cover Removal" on
page 114.
2. Remove the L Side Cover as described in "L Side Cover Removal" on
page 116.
3. Remove the I/C Holder Cover as described in "I/C Holder Cover Removal"
on page 116.
4. Remove the H Top Cover as described in "H Top Cover Removal" on
page 117.
You may find it helpful to manually release the Carriage Lock
by pushing down the cutter and move the carriage away from
the capping position.
5. Remove three screws (CPPM3x6) securing the CR board, and remove one
screw (CP(W)M3x6) securing the ground line, washer (M3), and CR board
guide.
Screw,
ground
line, and
washer
Figure 4-38. CR Board Guide Removal
Disassembly & Assembly
CR board guide
Three screws
Disassembly Flow
6. While holding down the CR Board (left edge), remove two FFC cables
from the FFC lock-type connectors.
FFC to printheads
CR Board
Figure 4-39. CR Board FFC Removal
7. While holding down the CR Board (left edge), remove three connectors
from the CR Board.
Connector (white,
Connector (black, to
to CR encoder)
P_Edge sensor)
CR Board
Figure 4-40. Connector and CR Board Removal
8. Remove two screws (CPP M3x8), then remove the CR Board.
Revision B
FFC to Main Board
Connector (white, to
cutter solenoid)
Ground,
washer
Two
screws
132