Version; Control Panel - Epson Stylus PRO 7000 Service Manual

EPSON Stylus Pro 7000

VERSION

This function confirms the firmware version and dip switch settings.
[Pause] returns you
to previous menu
[SelecType]
Ver. Firm
Ver. Parameter Pnl XXX
Ver. Parameter Moe XXXX
Ver. DipSW
Ver. Main Rev
Ver. Panel Rev
[Item]
Figure 5-4. Version Menu Options
NOTE: The Dip switch
The dip switch located on the Main Board is a 2-bit switch,
SW-1 is LSB (Least Significant Bit) and SW-2 is MSB (Most
Significant Bit). For example, if JP1 = jumpered/ JP2 =
jumpered, the LCD will display "Ver. DipSW 0x03".
Parameter Moe is for the mechanism version.
Adjustment
XXXXXX
16 bit
hexadecimal
0~FF
16 bit
hexadecimal
0~FF
ON: 0
0x03
OFF: 1
XX
01
Self-Diagnostic Mode Menus

CONTROL PANEL

This function allows you to check the operation of the control panel buttons,
LED indicators, and LCD panel.
[Pause] returns you
to previous menu
[SelecType]
Panel: Key
Panel: LCD
Panel: LED
[Item]
[Pause] (press two times to exit "Panel: Key" function
Figure 5-5. Control Panel Check
"Key" check
The name of the button that is pressed appears. Press the [Pause]
button twice to exit the "Panel: Key" function.
"LCD" check
All dots turn on. If a dot is not on, the LCD is not working properly.
"LED" check
The LED indicators turn on in the following order and the name of the
indicator appears on the LCD when that indicator turns on.
Power, Pause, Ink End (K, C, Lc, M, Lm, and Y), Paper Out, Roll Auto
Cut, Roll Cut Off, and Sheet
Revision B
[Enter]
Panel: Key XXXXXX
"XXXXXX" = name of pushed button
All dots = ON
Panel: LED XXXXXX
"XXXXXX" = name of flashing LED
167