Load Xxx Paper; Load Paper; Paper Jam; Cover Open - Epson Stylus PRO 7000 Service Manual

EPSON Stylus Pro 7000

LOAD XXX PAPER

Problem
The selected paper source (according to the remote PP command)
and the paper type selected on the control panel do not match.
Solution
Load the correct paper or change the panel setting to match the type
of paper loaded in the printer.

LOAD PAPER

Problem
While paper is loaded, the Paper Release lever was pushed up to the
Release position.
Solution
Make sure paper is loaded properly and push down the Release lever
to lock the paper in place.
If this error occurs even when the lever is down, in the Lock position,
there may be a problem with the Paper Release lever sensor. Check
the sensor operation, sensor connection, and board.
Troubleshooting

PAPER JAM

Problem
A paper jam occurs when during printing, paper feeding, or paper
cutting the carriage is not able to move properly (due to paper
catching on some part). The printer determines a paper jam has
occurred if the P-Front sensor and P-Rear sensors are in the "on" state
but the CR motor is out of step or has overcurrent.
Solution
After removing the paper stuck in the printer, the "TURN OFF AND
ON" message appears on the display. The printer is ready after you
turn the printer off and back on again.
If a paper jams occurs again after removing the original paper jam,
check to make sure nothing is blocking the feed path or blocking the
carriage.
Make sure the tabs of the Lower Paper Guide are inserted underneath
the metal that supports the subplaten.

COVER OPEN

Problem
The front cover is open.
This error occurs when the cover is opened during carriage operation
or a cleaning operation, causing the CR/PF operation and ink
sequences to stop. If the cover is left open too long, the printheads
may be damaged. (To avoid this problem, press the Pause button
before opening the cover. But be aware that a stripe may appear on
the printout indicating the different drying times.)
Solution
Close the cover as soon as possible.
If the cover is fully closed when this error occurs, make sure the left
and right cover-open sensors are correctly installed and are operating
properly.
General Errors
Revision B
100