Adjustment Outline; Adjustment Tools - Epson Stylus PRO 7000 Service Manual

EPSON Stylus Pro 7000

5.1 Adjustment Outline

This section describes the adjustment procedures necessary after replacing
certain parts and explains how to perform those adjustment procedures.
Before beginning any adjustment procedure, make sure of the following.
Before starting any adjustment procedure, find the
adjustment procedure you need to perform in Table 5-2 on
page 158 and verify the order or the tasks you need to
perform.
When performing an adjustment procedure, double-check
the detailed instructions and caution information for that
procedure; otherwise you may damage the printer.
To make proper adjustment, make sure to avoid strong
light (sun-light) around the printer. Since this printer uses
photo-sensitive devices (photo-sensors), the printer may
not function properly if it is operated under such
conditions.
When replacing the following, always install a new ink
cartridge.
• Printheads
• Main Board
• "Holder, Assembly, Valve"
Adjustment

5.1.1 Adjustment Tools

The necessary tools for performing adjustment procedures on this printer are
shown below.
Name
Tension Gauge
Tension Gauge
#F712
Straight edge/ruler
1000mm #F713
Scale Stopper
#714
Flash Memory Card
#F727
Self-Training Kit
#F733
Schema gauge
24 inch roll paper
A3 Tracing paper
A3 copy paper
Transportation
liquid; S46 (x6)
Adjustment Outline
Table 5-1. Adjustment Tools
Part Code
1054053/standard
Max. 10,000g
tool acceptable
B747700300/
standard tool Max. 2500g
acceptable
1047746/ standard
Length: 1000mm
tool acceptable
1047745/ standard Used in combination with #F713
tool acceptable (0.1mm scale)
1050073 Type: 2MB Flash memory card
standard Standard: Type-II (PCMCIA Rel 2.1/
JEIDA Ver. 4.2)
PC card
acceptable Voltage: 5V Read/Write
1053426 CD-ROM based service tool
standard tool
0.6 & 0.7 mm
acceptable
EPSON special Necessary for mechanism-adjustment
media printouts
Kimoto brand:
Necessary to determine P_FRONT and
MicroTrace
P_REAR sensor volumes
#300LMB
standard paper Necessary to determine P_EDGE
acceptable sensor volume
For cleaning and transportation
1045585
purposes
Revision B
Notes
157