Epson Stylus PRO 7000 Service Manual page 140

EPSON Stylus Pro 7000
4.2.3.10 Removing the Ink Cartridge Sensor
1. Remove the Ink Cartridge Slot as described in "Removing the Ink
Cartridge Holder & Slots" on page 137.
2. Remove the Ink Cartridge Sensor cable from the hooks as shown below,
and then remove the cable completely through the bottom.
Figure 4-56. Ink Cartridge Sensor Cable Removal
3. Remove the screw (CBS M3x10) securing the Ink Low sensor and remove
the sensor.
I/C slot
needle
Two
screws
(M3x6)
Figure 4-57. Ink Low Sensor Removal
Disassembly & Assembly
Slot frame
Hooks
Ink Low
sensor
One screw
(M3x10)
4. Remove two screws (CUPS M3x6) securing the needle frame and remove
the frame.
5. Remove one screw (CBS M2x8) securing the I/C sensor to the needle
frame and remove the I/C sensor.
I/C sensor
Disassembly Flow
One screw
Figure 4-58. I/C Sensor Removal
Revision B
140