Epson Stylus PRO 7000 Service Manual page 150

EPSON Stylus Pro 7000
4.2.3.19 Removing the HEAD_SLIDE Sensor Assembly
1. Remove the R Side Cover as described in "R Side Cover Removal" on
page 114.
2. Remove the Rear Cover as described in "Rear Cover Removal" on
page 118.
3. Disconnect the harness for the HEAD_SLIDE Sensor Assembly from its
connector on the main board and take the harness out from the hole in
the R Side Frame.
Clamp 1/4
HEAD_SLIDE
Sensor
Assembly
Disassembly & Assembly
Clamp 2/4
Screw
(M3x6)
Figure 4-76. Removing the HEAD_SLIDE Sensor Assembly
Disassembly Flow
4. Push the carriage lock using your finger to unlock the carriage and move
the carriage from the home position to the left.
5. Remove the one (CP(W) M3x6) screw securing the HEAD_SLIDE Sensor
Assembly and remove the HEAD_SLIDE Sensor Assembly.
6. Release the harness for the HEAD_SLIDE Sensor Assembly from the four
cable clamps on the Maintenance Assembly and CR Rail Assembly.
Clamp (on
Sensor
the CR rail)
Harness
Revision B
Clamp (on the
Maintenance
Base)
150