EPSON Stylus Pro 7000
4.2.3.7 Removing the CR Encoder Sensor
1. Remove the cutter housing as described in "Removing the Cutter
Housing" on page 133.
2. Remove one screw (CPP M3x8) securing the CR Encoder Sensor, ground,
and washer (M3). Then remove the CR Encode Sensor.
Figure 4-47. CR Encoder Sensor Removal
Disassembly & Assembly
CR Encoder
Sensor
One screw
Disassembly Flow
4.2.3.8 Removing the P_Edge Sensor
1. Remove the cutter housing as described in "Removing the Cutter
Housing" on page 133.
2. Remove one screw (CBP M3x6) securing the P_Edge sensor and remove
the sensor.
P_Edge sensor
Inner Face
Figure 4-48. P_Edge Sensor Removal
Revision B
One screw
Outer Face
136