Epson Stylus PRO 7000 Service Manual page 43

EPSON Stylus Pro 7000
Code page = PC 437 (US/Europe) or PC 850
Version = Firmware version
Ink Left = see below
E***** F 100~81% remaining
E**** F 80~61% remaining
E*** F 60~41% remaining
E** F 40~20% remaining
E* F 20%~near end
nn% near end ~ ink end (Ink End LED = flashing)
0% ink end (Ink End LED = on)
Cutter Life
The values are approximate and will vary depending on usage.
Table 1-33. Cutter Life Value
Printed Value
E*****F
E**** F
E*** F
E** F
E* F
E F
When the cutter life = less than 1%, the cutter should be checked (it is OK if it
cuts a clean, straight line) and replaced if necessary. This is a subjective check
and the cutter does not have to be replaced if it still cuts properly.
Users can replace the cutter themselves.
Page count = total number of printed pages (max. six digits)
Product Description
Meaning
100-81% remaining
80~61% remaining
60~41% remaining
40~20% remaining
20~1% remaining
less than 1% remaining
SelecType Settings
Ink Pad = waste ink count, see below
E***** F 100~81% remaining
E**** F 80~61% remaining
E*** F 60~41% remaining
E** F 40~21% remaining
E* F 20~1% remaining
E F Less than 1% remaining (Maintenance Req 0100)
when the ink pads are calculated to be full, Service Req. 00000100 occurs
and the printer cannot print.
After replacing the waste ink pads, clear the waste ink counter with
Maintenance Mode 2. See page 50.
CR Motor life = Monitors carriage passes to notify when ink tubes
need replacing. See above for count explanation. Service Req.
00000101 occurs when the count equals 0.
PF Motor life = Monitors the feed drive mechanism. See above for
count explanation. No fatal error.
Head = Keeps track of the number of dots fired from the head
according to color. The color that has been fired most is shown on the
Status Sheet. See above for count explanation. No fatal error. Part
replacement is determined on site.
Cleaner = Keeps track of the number of head cleaning operations
(wiping/rubbing). See above for count explanation. No fatal error. Part
replacement is determined on site.
Revision B
43