Service Call 00010009; Service Call 0001000A; Service Call 0001000B; Service Call 0001000C - Epson Stylus PRO 7000 Service Manual

EPSON Stylus Pro 7000

SERVICE CALL 00010009

Problem
System interrupt watchdog time-out error due to sensor-related error
Solution
Replace the Main Board

SERVICE CALL 0001000A

Problem
CR origin sensor malfunction - CR home position sensor malfunction
Solution
Make sure the CR HP sensor is not twisted or bent
Replace the CR HP sensor
Replace the Main Board

SERVICE CALL 0001000B

Problem
PF origin sensor malfunction - PF home position sensor malfunction
means motor replacement
Solution
Check the PF motor and sensor connections
Replace the PF motor (internal sensor)
Replace the Main Board

SERVICE CALL 0001000C

Problem
PG origin sensor malfunction (may indicate PG motor malfunction)
Solution
Make sure there is no ink or dust on the surface of the sensor. If this
does not solve the problem, check the PG sensor connection. If there
still is a problem, try the following.
Replace the PG sensor
Troubleshooting
SERVICE CALL 0001000D
SERVICE CALL 0001000E
Problem
Cover sensor malfunction - one or both cover open sensors (interlock
switch) located at either end of the cover shaft is malfunctioning.
(00):
(01):
Solution
Make sure the sensor(s) are properly installed. If that does not solve
the problem, check the cover open sensor connection. If there still is a
problem, try the following.

SERVICE CALL 0001000F

Problem
CR motor PWM output error
Solution

SERVICE CALL 00010010

Problem
PF motor PWM output error
Solution
Errors That Require a Service Technician
Replace the PG motor
Replace the Main Board
right sensor (HP side)
left sensor
Replace the malfunctioning cover sensor
Replace the Main Board
Check the cutter housing, slightly loosen screws if necessary
Replace the Main Board
Replace the Main Board
Revision B
97