Epson Stylus PRO 7000 Service Manual page 109

EPSON Stylus Pro 7000
Danger of explosion if the battery is incorrectly replaced.
Replace only with the same or equivalent type
recommended by the manufacture. Dispose the used
batteries according to government's law and regulations.
Risque d'explosion si la pile est remplacée
incorrectment. Ne remplacer que par une pile du même
type ou d'un type équivalent recommandé par le
fabricant. Eliminer les piles déchargées selon les lois et
les règles de sécurité en vigueur.
Disassembly & Assembly
Before servicing or performing maintenance on the
printer, make sure you have enough space. If you need to
move the printer, be sure the space you move to is safe.
Because the printer is much heavier than most printers
(about 44Kg for the printer body/ 53Kg for the printer and
stand), you need to take extra care. If you need to take
apart the printer and stand or lift the printer, two people
are necessary.
After removing any of the ink related parts, double check
to make sure all parts are secured; otherwise you're going
to be in big trouble.
Ink may leak onto other printer parts or the printer basket
when removing printer parts, so it is recommended to put
a sheet or cloth under the printer, especially when
working on or near ink-related parts.
When working on the electrical circuit boards, be careful
concerning static electricity which can cause damage to
the board. It is recommended you use an anti-static wrist
band or similar grounding device to prevent static
electricity buildup.
When removing/re-inserting the flat-cable (FFC) from/to a
connector, make sure to pull/insert the cable at a 90
degree angle to the connector. Otherwise, internal
contact of the leads may be damaged and this can cause a
short-circuit.
When replacing connector wires, be careful to replace the
entire length of the wire exactly as you found it; rubbing
against edges or moving parts can cause noise in the
wires.
The cutter blade is very hard and can damage or scratch
printer parts, and it can also be chipped or damaged. Be
careful when handling or replacing the cutter.
If you have to loosen a screw that has blue screw-lock
applied to its head, make sure you apply blue screw-lock
again when reassembling.
Summary
Revision B
109