Epson Stylus PRO 7000 Service Manual page 134

EPSON Stylus Pro 7000
Do not tighten the four screws securing the cutter housing too
tightly. They can pull out the female screws on the carriage
side, which warps the cutter housing. Since the encoder
sensor is attached to the cutter housing, the encoder may have
problems (trust me!).
If you run into the following or similar errors after replacing
the cutter housing, loosen the screws a little and try again.
Service Req. 0001000F
Service Req. 00010006
Figure 4-43. Cutter Housing Outer Face
Disassembly & Assembly
Cutter
guide
height lock
secured in factory
Cutter
guide
NOTE: The above cutter guide height adjustment is for your
Disassembly Flow
Hole shaped like
"T"; slide over
corresponding part
of carriage to
secure the cutter
housing
Figure 4-44. Cutter Housing Inner Face
Cutter guide height lock
Cutter height
determined and
then screw
Figure 4-45. Cutter Height Determination (factory adjustment)
information and should not be necessary under normal
circumstances.
Revision B
Cutter
guide
P_EDGE
sensor
Cutter guide
Faces the ink
holder side
The up/down
movement range is
limited by the
frame of the cutter
guide height lock.
134