3Com Switch 4500 26-Port Configuration Manual page 38

36 C 1: G S
HAPTER ETTING TARTED
Table 24 Setting the Command Level used after a User Logs In
Operation
Restore the default
command level used after
a user logs in
By default, the specified logged-in user can access the commands at Level 1.
Setting the Command Level used after a User Logs In from a User
Interface You can use the following command to set the command level after a
user logs in from a specific user interface, so that a user is able to execute the
commands at such command level.
Perform the following configuration in User Interface View.
Table 25 Setting the Command Level used after a User Logs In from a User Interface
Operation
Set command level used after a user logs in from a
user interface
Restore the default command level used after a user
logs in from a user interface
By default, a user can access the commands at Level 3 after logging in through the
AUX user interface, and the commands at Level 0 after logging in through the VTY
user interface.
When a user logs in to the Switch, the available command level depends on two
points. One is the command level that the user is allowed to access, the other is
the set command level of this user interface. If the two levels are different, the
former will be taken. For example, the command level of VTY 0 user interface is 1,
however, you have the right to access commands of level 3; if you log in from VTY
0 user interface, you can access commands of level 3 and lower.
Setting the Command Priority The following command is used for setting the
priority of a specified command in a certain view. The command levels include
visit, monitoring, system, and management, which are identified with 0 through 3
respectively. An administrator assigns authorities as per user requirements.
Perform the following configuration in System View.
Table 26 Setting the Command Priority
Operation
Set the command priority
in a specified view.
Restore the default
command level in a
specified view.
Do not change the command level unnecessarily for it may cause inconvenience
with maintenance and operation.
Command
undo service-type { ftp [ ftp-directory ]
lan-access | { ssh | telnet | terminal }* }
Command
command-privilege level level view view command
command-privilege view view command
Command
user privilege level level
undo user privilege level