3Com Switch 4500 26-Port Configuration Manual page 267

Table 289 Enable/disable info-center
Operation
Enable info-center
Disable info-center
Info-center is enabled by default. After info-center is enabled, system
performances are affected when the system processes much information because
of information classification and outputting.
2 Configuring to output information to the control terminal.
Perform the following operation in System View.
Table 290 Configuring to Output Information to Control Terminal
Operation
Output information to Console
Cancel the configuration of
outputting information to Console
3 Configuring the information source on the Switch.
With this configuration, you can define the information sent to the control
terminal that is generated by which modules, information type, information level,
and so on.
Perform the following operation in System View:
Table 291 Defining Information Source
Operation
Define information source
Cancel the configuration of
information source
specifies the module name;
modu-name
refers to the severity levels;
The information with the level below it will not be output.
specifies the channel number and
When defining the information sent to the control terminal,
must be set to the channel that corresponds to the Console
channel-name
direction.
Every channel has been set with a default record, whose module name is
and the module number is 0xffff0000. However, for different channels, the default
record may have different default settings of log, trap and debugging. When there
is no specific configuration record for a module in the channel, use the default
one.
If you want to view the debugging information of some modules on the Switch,
you must select
debugging
source, meantime using the
Switch of those modules.
Command
info-center enable
undo info-center enable
Command
info-center console channel{
channel-number | channel-name }
undo info-center console channel
Command
info-center source { modu-name | default }
channel { channel-number | channel-name } [ {
log | trap | debug }* { level severity |
state state }* ]
undo info-center source { modu-name | default
} channel { channel-number | channel-name }
default
specifies the severity level of information.
severity
channel-name
as the information type when configuring information
command to turn on the debugging
debugging
Logging Function
represents all the modules;
channel-number
specifies the channel name.
channel-number
265
level
or
default