3Com Switch 4500 26-Port Configuration Manual page 319

Table 350 Pubic key configuration
Operation
Enter the public key view
Exit the public view and return to the
system view
The configuration commands are applicable to the environments where the server
employs RSA authentication on SSH users. If the server adopts password
authentication on SSH users, these configurations are not necessary.
8 Entering the public key edit view
After entering the public key view by the rsa peer-public-key command, you can
use the public-key-code begin command to enter the public key edit view and
input the public key of the client.
When inputting the public key, you may type spaces between the characters (the
system will delete the spaces automatically), or press <Enter> and then continue
to input the key. Note that the public key must be a hexadecimal string coded in
the public key format.
Perform the following configuration in public key view.
Table 351 Enter the public key edit view
Operation
Enter the public key edit view
9 Exiting the public key edit view
Use this configuration task to return from the public key edit view to the public
key view and save the input public key. Before saving the input public key, the
system will check the validity of the key:
If the public key string contains any illegal character, the configured key is
■
invalid;
If the configured key is valid, it will be saved to the public key list.
■
Perform the following configuration in public key edit view.
Table 352 Exit the public key edit view
Operation
Exit the public key edit view
10 Specifying the public key for an SSH user
Use this configuration task to specify an existing public key for an SSH user.
Perform the following configuration in system view.
Table 353 Specify the public key for an SSH user
Operation
Specify the public key for an SSH user
SSH Terminal Service
Command
rsa peer-public-key key-name
peer-public-key end
Command
public-key-code begin
Command
public-key-code end
Command
ssh user username assign rsa-key
keyname
317