Displaying And Debugging Ip Address - 3Com Switch 4500 26-Port Configuration Manual

Switch 4500 family 26-port, 50-port, pwr 26-port, pwr 50-port
Hide thumbs Also See for Switch 4500 26-Port:
Table of Contents

Advertisement

82
C
5: N
HAPTER
ETWORK
Displaying and
Debugging IP Address
P
O
ROTOCOL
PERATION
The IP address configuration is described in the following sections:
Configuring the Hostname and Host IP Address
Configuring the IP Address of the VLAN Interface
Configuring the Hostname and Host IP Address
The host name is corresponded to the IP address by using this command. When
you use applications like Telnet, you can use the host name without having to
memorize the IP address since the system translates it to the IP address
automatically.
Perform the following configuration in System View.
Table 76 Configuring the Host Name and the Corresponding IP Address
Operation
Configure the hostname and the
corresponding IP address
Delete the hostname and the corresponding
IP address
By default, there is no host name associated to any host IP address.
For further information on IP Address configuration, please refer to the Getting
Started Guide that accompanies your Switch.
Configuring the IP Address of the VLAN Interface
You can configure an IP address for every VLAN interface of the Switch.
Perform the following configuration in VLAN Interface View.
Table 77 Configuring the IP Address for a VLAN Interface
Operation
Configure IP address for a
VLAN interface
Delete the IP address of a
VLAN interface
By default, the IP address of a VLAN interface is null.
After the above configuration, enter the
the IP addresses configured on interfaces of the network device, and to verify the
effect of the configuration.
Table 78 Displaying and Debugging IP Address
Operation
Display all hosts on the network and the
corresponding IP addresses
Display the configurations of each
interface
Command
ip host hostname ip_address
undo ip host hostname [ ip_address ]
Command
ip address ip_address { mask | mask_length }
undo ip address ip-address { mask | mask_length }
display
Command
display ip host
display ip interface interface_type
interface_num
command in any view to display

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents