Configuration Example - 3Com Switch 4500 26-Port Configuration Manual

256 C 15: S
HAPTER YSTEM

Configuration Example

M D
AINTENANCE AND EBUGGING
Table 277 Configure Remote-ping (continued)
Operation
Configure the test Configure
parameters the
destination IP
address of
the test
Configure
the type of
the test.
Configure
the packet
sending
times in each
test.
Configure
the
automatic
test interval.
Configure
the timeout
time of the
test.
Execute the test
Display test results
The remote-ping test does not display test results. You can use the display
remote-ping command to view the test results.
You can use the display remote-ping command to check the test history as well as
the latest test results.
Network Requirement
Perform an remote-ping ICMP test between two switches. Like a ping test, this
test uses ICMP to test the RTTs of data packets between the source and the
destination.
Configuration procedure
1 Enable remote-ping Client.
[S5500] remote-ping-agent enable
2 Create an remote-ping test group administrator icmp.
[S5500] remote-ping administrator icmp
3 Configure the test parameters.
[S5500-remote-ping-administrator-icmp] test-type icmp
[S5500-remote-ping-administrator-icmp] destination-ip 10.10.10.10
[S5500-remote-ping-administrator-icmp] count 10
[S5500-remote-ping-administrator-icmp] timeout 3
4 Enable the test operation.
[S5500-remote-ping-administrator-icmp] test-enable
Command
destination-ip ip-address
test-type type
count times
frequency interval
timeout time
test-enable
display remote-ping { history
| results } [
administrator-name test-tag ]
Description
Required
By default, no destination IP
address is configured.
Optional
By default, the test type is
ICMP.
Optional
By default, the packet sending
times in each test is 1.
Optional
By default, the automatic test
interval is zero, which
indicating the test will be
performed only once.
Optional
By default, the timeout time is
3 seconds.
Required
Required
You can execute the command
in any view.