Download  Print this page

Preparing To Configure Passwords - HP Z400 Maintenance And Service Manual

Hide thumbs

Advertisement

Preparing to configure passwords

The Computer Setup (F10) Utility lets you create setup and power-on passwords.
There are three possibilities for setting passwords:
Define a setup password only
Define a power-on password only
Define both
When defining a setup password only, you cannot enter the setup utility without the password.
No password is needed to start from power-on.
When defining a power-on password only, the power-on password is needed to enter F10 Setup or to
start from power-on.
When defining both, the setup password is needed to enter F10 setup and can be used to start from
power-on.
The power-on password cannot be used to enter the F10 Setup Utility, but it can be used to start from
power-on.
One of the passwords will be required to start from power on.
After you create both passwords, you can use the setup password in place of the power-on password
as an override to log into the workstation (a useful feature for a network administrator).
NOTE:
You can only clear the passwords with the password jumper. Clearing CMOS does not clear
the passwords.
CAUTION:
Pressing the Clear CMOS button resets CMOS values to factory defaults and erases customized
information, including asset numbers and special settings.
To back up the CMOS settings, run the Computer Setup (F10) Utility and select Save to Diskette
from the File menu.
ENWW
Before pressing the Clear CMOS button, back up the workstation CMOS settings.
Preparing to configure passwords
217

Advertisement

Table of Contents

   Related Manuals for HP Z400

Comments to this Manuals

Symbols: 0
Latest comments: