Download  Print this page

Advertisement

6.
Push down on the expansion card retention clamp levers on the inside of the chassis to open the
retention clamp (1) as shown below.
Figure 5-51
Release the expansion card slot latch (2), and then carefully lift the card from the chassis (3).
7.
Install an expansion slot cover and close the expansion card retention clamp.
If the expansion card retention clamp does not close, ensure that all cards are properly seated,
and then try again.
126
Chapter 5 Replacing components
Removing the expansion card
ENWW

Advertisement

Table of Contents

   Related Manuals for HP Z400

Comments to this Manuals

Symbols: 0
Latest comments: