Download  Print this page

Advertisement

Installing a CPU

NOTE:
HP recommends that you do not swap processors (CPUs) from one system board to another.
To install a CPU:
1.
Power down the workstation (see
2.
Disconnect power from the workstation (see
3.
Remove the side access panel (see
4.
If your system has an airflow guide, remove it (see
5.
Remove the CPU heatsink (see
6.
Remove the CPU (see
7.
Using extreme care, fully raise the CPU socket lever and cover.
CAUTION:
care when installing the CPU in the socket.
8.
Align the notches in the CPU base with the tabs on the socket as shown in the figure below.
Seat the CPU into the socket. Ensure that the underside of the CPU is level with the top of the CPU
socket.
Figure 5-83
9.
Close the CPU cover plate by lightly pressing down on the CPU cover plate while closing the
socket lever.
10.
Replace the CPU heatsink (see
158
Chapter 5 Replacing components
Predisassembly procedures on page
Removing the side access panel on page
Removing the CPU heatsink on page
Removing a CPU on page
The CPU socket contacts are delicate. To avoid bending the contacts, use extreme
Seating the CPU
Installing the CPU heatsink on page
Predisassembly procedures on page
Removing the airflow guide on page
157).
155).
75).
75).
78).
110).
154).
ENWW

Advertisement

Table of Contents

   Related Manuals for HP Z400

Comments to this Manuals

Symbols: 0
Latest comments: