Download  Print this page

Advertisement

5.
Push the hard disk drive into the selected bay until it snaps into place (1), as shown in the
following figure.
Figure 5-58
6.
Attach a power cable (2) to the drive, and attach a data cable (3) from the SATA port or SAS
controller to the hard disk drive.
CAUTION:
use a data cable with a right-angle connector when you install a HDD in bay 1 or bay 2.
NOTE:
on the system board (for SATA HDDs) or SAS controller card (for SAS HDDs). To identify hard disk
drive connectors, refer to the workstation service label on the side access panel.
7.
Replace all components that were removed in preparation for component installation.
ENWW
Installing the HDD drive
To avoid crushing or pinching the data cable when you replace the access panel,
For SATA and SAS HDDs, connect data cables to lower-numbered drive connectors first
Removing and installing components
133

Advertisement

Table of Contents

   Related Manuals for HP Z400

Comments to this Manuals

Symbols: 0
Latest comments: